for Builders & GCs
6 listings for plumbing contractors in Sacramento County on Cablanico,
the B2B network where builders and GCs hire their trades.
6contractors5licensed6with websites
Public directory
Plumbing subcontractors install, repair, and maintain water supply, drainage, and gas piping on residential and commercial projects. General contractors, builders, and remodelers typically bring a plumbing sub in for rough-in on new construction, repipes, water heater and tankless conversions, slab-leak repairs, and fixture set-out on remodels. The scope usually lands in two or three mobilizations: underground or under-slab work before the pour, top-out rough-in once framing is up, and trim-out after finishes. A plumbing sub's real value shows in how reliably they hit those windows without holding up concrete, framing inspections, or drywall. On permitted jobs the plumbing scope is usually inspected separately, and coordination points multiply on projects with fire sprinklers, radiant heat, or gas appliance packages, where the plumbing sub has to sequence against mechanical and electrical crews working the same walls and ceilings. When comparing bids, look past the bottom line to what is actually carried: fixture allowances versus owner-supplied fixtures, water heater venting, condensate routing, cleanout locations, and who patches penetrations. Ask how the sub handles change orders when field conditions differ from plans. Older buildings in particular tend to surprise once walls open up. In California, plumbing contractors typically carry a CSLB C-36 classification; before contracting, we recommend confirming that a subcontractor's license and insurance are current; both California and Texas publish free public license lookup tools.
Ideally at preconstruction pricing, and on site before any slab pour, since under-slab drainage has to be in, tested, and inspected before concrete. Top-out rough-in then runs alongside framing completion, and trim-out lands near the end of finishes, so the same sub touches the job at least three times.
We recommend confirming the license classification and its status (CSLB in California, TSBPE in Texas; both publish free public lookup tools), current liability and workers' comp insurance, and references from projects of similar scope. For gas work, ask specifically about experience with the local inspector's expectations.
It varies by scope. The main drivers are fixture count, whether work is new rough-in versus repipe in occupied space, slab versus raised foundation, gas scope, and the fixture allowance carried in the bid. Comparing what each bid actually includes matters more than the bottom-line number.
Concrete (under-slab timing), framing (top-out routing and blocking), HVAC and electrical (shared wall, ceiling, and mechanical-room space), and drywall (cover inspections must pass first). On sprinklered buildings, the fire-sprinkler contractor's mains usually take routing priority.
Practice genuinely varies, which is why fixture supply is a recurring scope dispute: some plumbing bids carry a fixture allowance, others price labor-only against GC- or owner-furnished fixtures while still supplying rough materials, angle stops, and supply lines. Spell out in the subcontract who purchases, receives, and warranties each fixture, because setting an owner-supplied fixture usually leaves the manufacturer warranty with whoever bought it, not the installer.
Ask how discovered conditions like failed galvanized supply lines, corroded cast-iron drains, and out-of-code venting get priced once walls are open, and whether the sub flags them before proceeding. Agreeing on unit pricing for the common surprises up front keeps an occupied-remodel schedule honest.
